Epson Perfection V200 Flatbed Scanner "not power" Questions

not power on after following the checks above, contact Epson for support. If your scanner uses an AC adapter, then this may need to be replaced. If your scanner is over 12 months old, you can purchase

power adapter (more common) or a bad mainboard. test the connector with a volt meter and see if you are getting power, if so, bad main board, if not bad adapter. power adapter is $32 main board is $49

...not get any power. I have checked all cables and everything looks fine. Any ideas of what else I can check? Thanks for your help. Unplug the power supply from the power port on the scanner then plug ...

...power cut for about 5 or 10 minutes, about 5.30 yesterday & since then my Epson 4990 scanner has not worked, the red light flashes & a Loud knocking noise starts. What has happened & how ...

...not turn on. I checked the power cords -- all in order. Can these just "die"? yea scanners can die. i would test the power supply to see if the cord got fried. usually they have a big box somewhere ...

...you can not get any cheaper than this... please do not forget to rate if this was helpful... have a good day

Epson 3170 scanner will not power on power supply is probably bad. cost is $35 or the main board at $53.

...power supply in the back. The On/Off button does not turn the unit off. Any suggestions? Otherwise, the scanner works fine. The Epson scanner (about 8 yrs old) doesn't shut off when attached to an ...

...power at all Not sure why it burnt going from 240 down to 110volts. The unit should not have worked. However, if it is a 110 volt machine and you plugged it into 240 volts... different story... At ...

not locked for transport. Harry Watts This noise is caused by the transport lock. Power the scanner off. Lock and unlock the transport lock a few times and then leave it in the unlocked position again