Frigidaire GLTF1240A Front Load Washer "water bellow drum" Questions

...bellow (door gasket) for anything blocking the water inlet port into the washer (It's common for a sock(s) to get wedged up there and cause a blockage). Let me know if you need more assistance. Good ...

...bellow spring clamp. With towels handy (just in case), let the machine fill and agitate for a few minutes and check for water leaks. If all is well, re-install the kickplate and wash some laundry. ...

...water lines where washer cleaning doesn't reach and I did not see much of it. But what I did discover is that there is rust around the drain bellow. What could be causing that? Don't seem to see rust ...

...water leaks from where water fills drum. theres a hole in gasket (bellows),,,,now also check your detergent draw if water pressure is to high it will splash over and come down inside of

screws top front, two screws bottom front, loosen the doorlock and door bellow. Disconnect everything on the drum, (motor, dampers, heater, water pressure switch hose ect. Lift the drum out. Good luck

drum and the cabinet. Remove the kickplate for easier access and to visually check for leaks later. Starting at the top, pull on the bellows firmly (close to the tub) until it comes out of the groove.

drum. Be very careful when installing the new bellows gasket to get the water inlet section properly lined up with the fixed water inlet port, since you don't want to tear the new bellows and have the

...water level is controlled by a small pipe that goes into the drum somewhere low down and leads up to a little bellows device (It looks like a spinning top, about 4 inches or so in diameter with a ...

...bellow seal in the drum blocking the water inlet to the drum. You can just get your fingers between the metal of the drum and the rubber seal to feel the inlet which is below the detergent drawer. ...

...water runs into top of drum and out of bottom of drum and leaks out of bottom of drum through machine onto floor. I had the water pump replaced a year ago. The first thing to check is the bellows, ...