...stove panel went blank I presses the clock button it came on so I reset the clock a few minutes later it went blank again. A few days ago I came home and the clock was blinking like we lost ...
...stove and waited the 5 minutes. clock flashes - set clock (unsuccessful) then bake - unable to reset temp from 350 to 375 - f11 error code & beeps. should we reset the circuit breaker or just unplug ...
Question about Maytag Kitchen Ranges
...Stove / Oven Fault Codes Failure Code Fault Code Description Solution F0 Function key stuck Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). F1 Defective touch pad or ...
...stove clock malfunction.. I have an electric Whirlpool stove, about 10 years old. Recently, after the oven has been on for about one hour, the clock starts to blink, the time changes to 55:00, it ...
Question about Frigidaire Kitchen Ranges
clock to run.The solution was to replace the wall receptacle and the cord to the stove.To see if you have this problem start by unplugging the stove to see if the prongs on the plug are burnt. If they
...stove to clock face and make sure the harnesses are tightly fitted to clock board. You could even remove and reinstall the harnesses to the clock board. If able, check for 120v to clock. If clock is ...
...clock looses communication between the keypad or any of the sensor in the stove, including the heat probe. sometimes resetting the power will fix the problem. try disconnecting power to the stove ...
...How do you reset the clock To set the time. The top strip on the upright part of the stove , where the clock is, flips up. The directions are under it. oven sets only at 35O won t accept other ...
Question about Whirlpool Kitchen Ranges
...stove. PF = Power Failure. Sounds like you have a bad electrical connection. With your breaker off, check that the connections from the cord to the range are all good and tight. Next, check the ...
...resetting the control to factory defaults. If none of these work then replace the clock/control part number 5701M827-60. This part runs about $175.00 I attached a cut out of the service manual, to ...
510 questions posted
Usually answered in minutes!
213 Questions
158 Questions
123 Questions
110 Questions
92 Questions