Onkyo TX-SR605 Receiver "shuts power light blinking" Questions

...mode. The receiver protection circuit detects an internal problem like missing power supply voltage or blown channel and shuts down the receiver. You need to bring the unit to a repair

...shuts off with light blinking. I opened it up and the fuse is fine. What can I do to fix this problem? Blinking indicates that the power source has shut itself down because another component has died ...

...power light starting blinking rapidly. Unplugged unit to see if it would reset - to no avail. Standy/power light still blinking rapidly. Any ideas? Marantz SR 6001Power and StandBy Light came on and ...

power light starting blinking rapidly. Unplugged unit to see if it would reset - to no avail. Standy/power light still blinking rapidly. Any ideas? yup, first time yesterday... unplug, replug cured it

shuts off and lights blink on off These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section

shuts off with light blinking This means there is a problem with the system it is in the protect mode it will not come out of that mode untill repairs are made. More than likley the power amp is blown

...power light is blinking red. When I try to power it on again it starts to boot up but then turns off quickly with the same red blinking power light.... Adam speaker terminal are short circuit,switch ...

...power supply. Disconnect your speakers at the receiver and test again. You may have a wire shorted or a bad speaker. If it still shuts off, the problem is in the receiver and needs to be serviced. If ...

shuts off the power light blinks that was a long time ago havnt used it in over a yr now it turns off and the light blinks without any speakers being hooked up or any hooked up and will not stay on no

...not stay on power works but standby light will be on and display goes on but shuts off immediately. standby light just blinks. any solution? thank you The outputs are blown and will require