Mitsubishi WD-65733 65" HDTV "lamp inch tv" Questions

...inch DLP HDTV ywllow warning lamp light why is the yellow lamp warning light staying on on my Mitsubishi WD-52525 52-inch DLP HDTV that means your lamp it is getting to the end of its life. sometimes ...

...Inch 3D DLP HDTV I was watching it and it made a pop sound, then the screen went black what can I do..... Tv "LAMP" LED light indication on the tv frame word light up or blinking LED light.Check the ...

...brighter than my 82" set which also has a 180 watt lamp. ... any lightcoming in; it will cause rather bothersome reflections off the TV screen. Mitsubishi WD-92840 92-Inch 1080p 3D Projection TV

...lamp in my mitsubishi wd-52525 52 inch tv take off the speaker grill. next to the left speaker will be a door with like 2 or 3 screws holding it closed. take those out and your lamp is in there held ...

lamp my 62 inch mitsubishi tv is the worst. why does the lamp need to be replaced every 12 or 13 months at a cost of $250 each time. we have this tv 4 years and the lamp has been replaced 5 times. is ...

...inch dlp tv came on and was working then with out any noise or notice the picture went to black and a steady red light came on under the word "lamp". We looked at the bulb and it does not look burned ...

...inch Mitsu turn it on and it goes to a red light on the lamp signal. I replaced lamp and same problem any suggestions no picture or sound di you replace the power for the lamp in your manul it will ...

...LAMP IS SET BACK IN THE TV ABOUT 5 INCHES FROM THE LAMP DOOR SUGGEST A LONG FLAT HEAD SCREWDRIVER TO LOOSEN THE LAMP. INSERT NEW LAMP AND PUT LAMP DOOR BACK ON. THERE ARE INSTRUCTIONS IN YOUR OWNERS ...

...lamp issue! A/V Media Tech Guy. Good Day Judy, hi, as i see it, your 64 inch TV is on standby mode, this occurs when the Power Supply Board, (inside your TV that supplies good power from the main ...

Lamp Problems Turned on TV, 10 seconds loud pop sound, check lamp and it was damaged. Order new lamp installed still isn't working. Checked DC power to lamp (results Dead). Checked DC power input to ...