Sirius Satellite Radio Receiver "remove" Questions

...perfect now On some units, if your antenna wire is shorted the unit will not pass the logo screen. Remove antenna and see if it will pass the logo screen. If it does, your antenna is the issue. Your ...

...this exact same problem and I have solved it by the following method. Open the unit (2 screws), remove the silver box (3 screws and gold pin connectors), and remove the circuit board (2 screws). ...

...a processor fault. The fact that other buttons are unresponsive only bolsters my suspicions. Remove power from the radio - not merely powering off - but remove power from the power leads. You ...

...I open the MyFi? I think the antenna cable came disconnected or unsoldered. take off battery cover, remove battery, remove 'cardboard' and any screws you can see under the cardboard, Then carefully ...

...and get stuck down inside the hole - if you see a piece of yellow plastic down there, you need to remove it with a small pointed hobby knife (Xacto). After you remove that, then try plugging the ...

pioneer GEX-XMP3 stuck in the power up mode removed battery to reset did not fix problem what should i do Just off the phone with Pioneer customer service. Apparently a "software glitch" common enough

...rubberized finish is starting to break up and looks and feels horrible. Is there any way I can remove this finish? One owner on eham.com remarked that he soaked the cabinet in rubbing alcohol, ...

...will come off and get stuck like a horseshoe over the little center pin. You will need a needle to remove this little plastic circle. Once the broken-off plastic disc is removed, your adatper will ...

...the unit without removing any of the decals on the back of the unit. Did you get it open? remove the two screws. Those are all the screws on the outside. Gently pry the halves apart at the ...

problem is the scrolling wheel is broken. Is there a repair facility / Or a tool to remove the back plate ? All I can contribute is that you can remove the back part of the case with a Torx Screw ...