Samsung WF337AA Front Load Washer "three light error code" Questions

...LIGHT UP, LEAVE IT FOR TWO TO THREE SECONDS THEN TURN OFF. THIS RESETS YOUR MACHINE. I SPENT 90 MINS TRYING ALL COMBINATIONS, RECOMMENDED AND OTHERWISE, NONE WORKED. THIS DOES. MY FAULT WAS C9. MOTOR ...

...the machine gives 2 short beeps and lights up. Now press the Spin Speed Up button three times so that the Hold and Slow LEDs are illuminated. The eight wash progress LEDs will show the error

...three times/will not start. It has a digital display but no error code displays. Make sure you are closing door properly and not slamming it the latch assembly tends to be sensitive at times, try ...

...error code, so It can only be three things, Out of balance switch,Lid magnetic reed switch,Or Rotor position sensor,Your error code would help me work out witch one of these are faulty. to work out ...

...error codes from your Maytag BRAVOS MCT washing machine, you can try the following steps: Make sure the washer is in standby mode (all lights off). Select any three buttons (except POWER) and follow ...

three screws from the back top and look down the right front side and look with a bright light for any thing broken or loose. Then I would unplug the washer and trace the power connect back to the ccu

...light flashes 5 times what is this error code I need to know the fault for 5 green end flashes Press START/PAUSE and any one of the option buttons simultaneously for at least two seconds: the LEDs ...

...three times and the lights blink. It has done this in the past and after unplugging it or letting it set or awhile it would always start working again. This time it's not. I attempted to do an error ...

...light 1 and three quickly. Have to unplug to turn off. It did wash but then started to flash and didn't finish the cycle. Now when you put it on it fills then stops an Aquarius wf540 F10 Error Code : ...

...light then 3 three on end light only) help :) Hello, Error code 23 normally means a faulty triac on the drain pump or a fault with the wiring or even a faulty PCB, which could have been caused by the ...