...setting error photoconductor unit setting error appeared,the same was inserted again after necessary repair but still photoconductor unit setting error appears. What did you repair? as the pcu is an ...
...Error light (!) is displayed, close the front cover. The top four lights of the operator panel should come on, indicating that the printer is in configuration mode. Print the Configuration Settings ...
...error page that states "The printer has stopped because the photoconductor kit has reached the end of its useful life." What is a photoconductor kit and how is it fixed/replaced? The photoconductor ...
Question about Gestetner Office Equipment & Supplies
...error says set drum completely Please open the front door carefully and open the right door also and then remove the photoconductor unit unit and reset properly. If the problems persist , call an ...
Question about Dell Office Equipment & Supplies
...photoconductor kit has stopped working. I just replaced everything and keep getting the same error. If the drum cartridge has not been replaced, it must be replaced before resetting the counter to ...
Question about Dell Office Equipment & Supplies
...error message? please i need yuor help Turn the machine off. Open the access door and remove the cyan photoconductor unit. Check the contact pins are straight and undamaged. Gently reinsert the unit. ...
...error. Is your cyan toner low? You can try installing a new cyan toner, but if that doesn't do anything you'll probably need to replace the cyan PCU (photoconductor unit) or have a service technician ...
error. It could be caused by anything from a faulty circuit board to a bad motor, but the most likely fix (and the easiest) is to replace the color PCUs (photoconductor units) which I believe all come
Question about Dell Office Equipment & Supplies
...photoconductor (PC) drum counter, perform the following steps: 1. Turn off the power using the switch on the back of the printer. 2. Open the front door of the printer. 3. Hold the Continue button ...
...Error light (!) is displayed, close the front cover. The top four lights of the operator panel should come on, indicating that the printer is in configuration mode. Print the Configuration Settings ...
282 questions posted
Usually answered in minutes!
995 Questions
574 Questions
608 Questions
501 Questions
509 Questions