Question about Cooktops
...element: If the burner control switch is not the problem, the issue may be with the heating element. Check the element for visible damage, such as cracks, burn marks, or discoloration. If you see any ...
Question about Jenn-Air Cooktops
...burner element and the terminals labeled "L1" and "L2" (sometimes "N1" and "N2") are the power supply wires. Set yourmultimeterto ohms setting x1. Turn the burner control to the highest temperature ...
...get the burner to function as a large-size burner. The model # is: JBP78W Y1WW. The serial # is: MS246249G. The outer ring of the element is most likely broken. You'll need to replace the
ELEMENT BURNER NO LONGER HEATS THE OUTSIDE RING. HOW DO I TEST THE SWITCH AND THE BURNER WITH MY VOLT/OHM METER TO DETERMINE WHAT IS BAD? its been my experience that the dual burner switch is far more
Question about Cooktops
...come on or heat up. The power is on but the front burner wont heat up. All other burners work fine. Is it the switch or the element that needs replacing? could be either, but usually it is the ...
...burner element has visible blades that fit into the receptacle block, pinch the block with one hand, and pull the heating element free with your other hand. If the terminal block clamps over the ...
...burner to plug into. Could it be the ceramic element the burners connect to at the back of the burner unit? The smaller burner appears to work fine. Based on the symptoms described, it is possible ...
...The dial is on the off position. if it is a DOUBLE element burner you might of turned on the second element. double elements the reverse direction turns on. if single you have a short or a bad ...
...burner elements. One of the knobs does not work and a red light under the knob is on all the time. Also, not all burners are heating sufficiently. What to do? The switch under that knob is bad. It's ...
...element burner(right front) does not work the light does come on, the burner does not and the knob has play in it. This coulb be either the switch or the burner. Either can be tested with an ohmmeter ...
13 questions posted
Usually answered in minutes!
268 Questions
118 Questions
87 Questions
55 Questions
38 Questions