...reset drum and dev switc off the very quiqly service mode function run f8. Did you replaced drum and developer? (bizhub C203/C253/C353/C353P/C252/C300/C352/magicolor 8650)- Toner is not supplied due ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...should be replaced. The 'Replace Drum soon' message is just a warning to allow you time to purchase a drum, however dont replace it until the message reads 'Replace drum now' and then reset the ...
Question about OKI Office Equipment & Supplies
...image drum cartridge, reset the drum counter to keep a correct count of the number of pages printed on the image drum. 1. Turn the printer on while holding the MENU 1/Menu 2 button. USERMNT displays ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...key press *00 press OK did what was suggested the reset message reset 4-6 reset 4-9 the message did not ask replace I want to replace drum n y new waste toner box installed, but error message ...
Question about Konica Minolta Office Equipment & Supplies
...replace the drum unit for you. Don't listen to anyone that gives you the service mode entry procedure and drum count reset. This WILL screw up the AIDC (Automatic Image Density Control) and the ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...reset it? All you should have to do is: -replace the old drum with the new replacement. -with the front door open press the Clear/Back button -press the number 1 button and when ?accepted? appears on ...
...reset the photoconductor drum counter, press and hold the Cancel button on the printer until all lights flash in sequence. You can clear the Replace photoconductor message only when the imaging drum ...
Question about Sharp Office Equipment & Supplies
...replace drum cartridge" which I have done alreay. Still won't cler the flashing message. What can I do to correct this problem. I have replaced both cartriges and cleaned it before I put the ...
Question about Samsung Office Equipment & Supplies
...image drum: MAGENTA DRMCNT RESET c. Press the ENTER/POWER SAVE button. RESETTING briefly appears on the display. d. Press the ON LINE button. If I could be of further assistance, let me know. If this ...
...reset the counters when in fact he developer is old and so might be the drum which can cause codes and image problems. If the developer was replaced where the counters cleared !ST!!!!!!!!!!!!!!! and ...
325 questions posted
Usually answered in minutes!
1,023 Questions
924 Questions
417 Questions
261 Questions
111 Questions