MSI K9N6SGM-V (7309-020(K9N6SGM-V)) Motherboard "reset jumper" Questions

...shorts out bios and resets it. Computer will not start if the jumper is on the pins. Leave the jumper off after reset, or just change jumper to the other two pins if you have them on your mobo.. ...

...jumper reset The reset jumper is labelled JBAT1 (circled in red below). Pins 1+2 are jumpered/shorted right now, just turn the machine off, move the jumper over to short pins 2+3, wait 5-10 seconds, ...

...jumper to "Reset you're cmos/bios jumper to clear for 15 seconds, than move back jumper to default pins pg. 52. Try to enter you're bios? If you are not using a PCI-E card (which is preferred in ...

...reset your bios jumper. All boards have the jumper, you will move the jumper from it's current position to the next pin. Example. It has two pins. Jumper Pin 1 and 2. The jumper might current be set ...

cmos reset jumpers on the reset setting. check for one stand alone jumper across 3-pins, check readings on board for location of cmos reset jumpers & move jumper to bridge the unbridged connection

...reset jumper 1, I forgot my password, where is jumper 1 what does it look like ok..u don't need reset the jumper..i'll try make it simple..disconnect all input mains power sources.."just remove or ...

same problem says entering setup but goes no where reseted the cmos w jumper form 1-2 to 2-3 waited 5 secs then put jumper back to 1-2 still same symtom cmos jumper from 1-2 to 2-3 and then switch on ...

...reset password by jumper on motherboard his name CMOS CLEAR or CMOS RESET . it plased near the 3 volt battery . It look like 3 pins a 1 jumper on it. reinstall for 2 second jumper to anover two pins ...

...is OFF and place onto pins 1 and 2. Power on your machine for a minute. (Note: Your system will not POST). Shutdown your machine and put the jumper back to pins 2 and 3. Your reset is now ...

...RESET all settings with jumper settings. Find jumper on mothebord named "Clear Cmos" It has 3 pins 1-2-3 Set jumper in 2-3 position then power up the computer then again put jumper in 1-2 position ...