Whirlpool LGR5636L Gas Dryer "belt keeps breaking" Questions

...belt keeps breaking We have an older model, gas powered Kenmore Ultra Fabric Care that has a broken drum belt. We have replaced the belt twice with the only belt that supposedly fits (part # 341241). ...

...keeps breaking belt replaced belt twice in the last 3 months and the drum will stop turning even with the new belt like it is slipping and then the belt breaks. Checked all wheels and they are free ...

belt keeps breaking Could be a dozen things, from some kind of tension device that has failed to mis-alignment or over tightening of the belt. If you look at the broken belt, does one side of the belt

...keeps breaking belts this is 2 belts in less than 2 months what is causing this to happen Check the idler pulley, if not turning freely, the belt may have excessive friction against pulley wheel, ...

...may not be installed on the belt tensioner correctly check the idler pulley near the motor that keeps tension on the belt,they lose their spring tension or break and you lose belt tightness on the ...

...belt on a ned4500vq0 Remove the filter, pop the top. take the front off (lift up a hair to keep from breaking the mounts)Take the drum out and clean her up. Oil the wheels and idler. Place the idler ...

...belt t9800 keeps breaking worn felt seal on the front of the drum.  felt has worn away exposing the rubber,  when the dryer gets warm the rubber gets sticky.  this causes loud ...

...belt tight and to prevent it from breaking when the dryer is started. You should be able to access the belt by raising the top (lid) of the dryer. There are screws underneath to remove the front of ...

kenmore gas dryer model# 110.73112100 heat is on, drum not turning Sounds like broken belt on older models it will not know if the belt breaks and will keep heating and motor running

...keeps breaking belts. Drum seems to jam at door end and motor contines to melt the belt.The bearings are good . The dryer is only 18 months old. Every time belt breaks when I investigate it the drum ...