...hot water is shutting off but the cold water is not. The tub fills to overflowing with cold water and we get a wet floor. Any Idea what I need to replace? Sounds like the cold water valve is faulty. ...
Question about Daewoo Washing Machines
...? replace the water shutoff solenoid valve assembly in the mean time when the machine is full turn the tap off change the hot water hose over to the cold water tap and use the hot water solenoid ...
Question about Kenmore Washing Machines
...cold solenoids ( hot and cold water hoses ) and you are not using the hot just swap the hoses over and only use the hot water settings that way the cold water comes in through the hot water ...
Hot water will not stop flowing. Hot water Hot water will not stop flowing. Hot water started flowing at the usual time in the new washing cycle, and did not stop. Although hot water was flowing ...
Question about Whirlpool Washing Machines
Hot the water stops bad water valve on the washer.shut the hot water off at the shutoff.disconnect the hot water hose going to the washer and stick it into the washer or a sink and turn it on,if water
Question about Maytag Washing Machines
...the water inlet valve or water temperature switch the problem? Check the inlet screen on the hot water hose at the inlet to the machine and the shutoff valve too. It's possible it's partially
...hot water heater I recently installed a new hot water heater and now i have no pressure any where in the house. The only connections I redid was at the heater. The state water heater I installed had ...
...water shutoff valve can't close I bought another washing machine so I need to remove the old one. Before removing the hose from hot and cold valve i need to close the valve, but I couldnt. Its very ...
Question about LG Washing Machines
...water valves (hot or cold) supplying the washer with water has been turned off or closed. 2. Your washer has a shutoff valve on the back that may be in the closed position. 3. There may be a water ...
...water inlet 3 way valve is working right. there are 3-110 volt coils that should have a white, brown and blue connector. the white one usually supplies voltage first (depending on mode used). try a ...
253 questions posted
Usually answered in minutes!
9,125 Questions
2,624 Questions
2,038 Questions
1,413 Questions
1,373 Questions