dryer and check if drum turns freely by hand. Check L1 power supply voltage, motor windings, and motor thermal protector (if motor thermal protector has tripped, it may take up to 30 minutes to reset)
...thermal protector is located. Im getting code error CI. Thanks Thermal overload protector is mounted on the motor. Normally the motor is replaced. I had the same problem and had to replace the motor ...
...thermal protector on the MCU heat sink gets too hot, it will open the thermal protector on the heat sink which will stop motor functions and an F10 will be displayed. Potential Causes • Check for ...
thermal protector on the MCU heat sink gets too hot, it will open the thermal protector on the heat sink which will stop motor functions and an "F/10" will be displayed. Check for Proper Installation,
...thermal protector on the MCU heat sink gets too hot, it will open the thermal protector on the heat sink which will stop motor functions and an ?F/10? will be displayed. 1. Check for proper ...
...thermal protector on the MCU heat sink gets too hot, it will open the thermal protector on the heat sink which will stop motor functions and an F10 will be displayed. Potential Causes ? Check for ...
...c1 gettin an error C 1 Error code C1 indicates a problem with drive motor-thermal protector or the motor controller may be due to overloading Press( stop/cancel) to clear the display. Hope this ...
...code 21740 Hi Error code C1 indicates problem with drive motor-thermal protector-or motor controller Overloading may also cause the problem. Press( stop/cancel) to clear the display. Hope this ...
thermal protector-or motor controller Overloading may also cause the problem. Press( stop/cancel) to clear the display. If that does not help then, "C1 = Average current limit Or Instantaneous current
1,725 questions posted
Usually answered in minutes!
9,125 Questions
2,624 Questions
2,038 Questions
1,373 Questions
429 Questions