...off and on again then it goes in the correct direction. Also, how often should the rubber band be changed? the belt (aka rubber band) should be changed when it starts to slip it is not whats
Question about Technics Audio Players & Recorders
...change the belt Instructions on installation of your drive belt - this also applies to other brands as well - however this belt is only for the Technics models listed above: Remove the turntable ...
...change the speed. Spins very slowly. Is it the motor? The belt is fine.... It could be or the power supply to it. The best way to find out is to remove the motor from the circuit and connect a good ...
Question about Technics Audio Players & Recorders
I just changed the drive belt. Immediately following that, the motor is intermittent; it has worked a bit, but also cuts out for no apparent reason. Once it cuts out--happened twice--I cannot get it ...
Question about Technics Audio Players & Recorders
...motor is turning okay but belt is slipping. They are easy to change, first just lift rubber mat on platter and you should be able to see the belt through a access hole in the platter. I had the same ...
Question about Audio Players & Recorders
...any gunk from the rim where the belt turns the platter and do the same on the pulley on the motor. Get some de-oxit (expensive but good) or SERVISOL to clean the speed change switch too. ALL THE
Question about JVC Audio Players & Recorders
Why does the turntable on my JVC AL-E300 stop when the arm drops on to the record. Just changed belt. Does it restart if you manually lift the arm up? If it does then you might have not put the belt ...
my PS_X6 has started running slow? It looks like the platter mechanism is going bad. This is a direct drive and few things could be happening with either the motor speed is changing or the mechnism. ...
...You may find that the manufacturer provided straps on the motor that can be unsoldered and changed to adapt to various voltage and ithat the speed can be altered via a speed control knob on ...
Sony hmk-v82 turn table speed. The speed changes slightly all the time, tone in music goes up and down accordingly. What is the solution? This is known as wow and flutter. It's generally caused by the
116 questions posted
Usually answered in minutes!
325 Questions
254 Questions
185 Questions
116 Questions
97 Questions