...need to replace the lamp. Mine did this when my lamp burned out. You can try pressing and at the same time, and you'll get a code flashed out to you (tens digit followed by unit digit). You'll likely ...
...AND GOES BLACK WHEN I TURN ON MY TV IT BLINKS THE PICTURE THEN GOES OFF It may indicate the lamp needs replaced, or that the cooling fans are not turning. When the controller senses too much lamp ...
...fan. If either of these fans doesn't turn easily, they need lubricated. This will also cause an immediate shut-down, since over-heating is a major safety concern. If the fans and lamp are in good ...
...need to replace the whole Light Engine. Expect to pay $400+ for the Light Engine and $250+ in labor for someone to install it. It sounds like the lamp assembly has come apart (parts falling into the ...
...error 37. when I turn the tv on the lamp does turn on and the fan in front of it is turning. what else do I need to look at? i have the same tv i replaced the lamp n now its a oange blinking light ...
Question about Mitsubishi WD Televison & Video
...need replaced. Is it worth it or should I just get a new TV If the Lamp is OK then Look to see if Lamp Fan is running, Make sure all Fans are Running and if they are all OK then Problem could be the ...
need to be clean and turn easily. Color wheel fan needs to turn easily. If any one of these motors does not turn, the controller will cause a shut-down. The Xenon lamp uses high voltage to operate. If
Question about Mitsubishi WD Televison & Video
cause set not to come on and the ballast board is what turns Lamp on, it connects to Lamp. Make sure Lamp Fan is running it is what keeps Lamp cool when set is on.Let me know if you need any more help
Question about Mitsubishi WD Televison & Video
...lamp, now no fan & hot plistic smell, (of course) ok, replaced the lamp using an osram replacement into the orignal housing. habe done this previously, this time the fan doesn't come on & smellslike ...
...NEED HELP!!!!!! You have to take the TV apart. Pull the electrical chassis out and look for bad electrolytic caps on the boards. sounds like caps on the power supply board are bad. You can tell if ...
88 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions