...rotate the platter ClockWise a few turns to disengage any cueing mechanisms. Set the Tracking and Anti-skating controls to 0. Disengage the tonearm elevation control. The tonearm will either float ...
anti-skate adjustment. Set the antiskate adjustment to the same number as the needle pressure setting (i.e. 2.5 grams would be an anti-skate setting of 2.5). If you are back cueing or scratching, then
...anti skate setting at the back of the turn table, a round adjustable bit with numbers, increase the anti skate and then use the balance weigth (weight right at the back of the arm that turns to get ...
...anti - skate and tone arm hight on my turntables what are the proper specs, thanks. Anti skate should be set the same as the weight, i.e 3 gram of weight = 3 on the anti skate. ...
...anti skate settings. 1) The Headshell Weight and Balance Firstly, check the data sheet for the cartridge and stylus you are using. It should tell you the correct weight setting which will vary from ...
Question about Gemini Audio Players & Recorders
...anti-skate control as well (example if the arm is tracking at 2 grams, anti-skate must be set at 2). Follow these instructions for setting the counter balance: Turn the weight so that the arm is just ...
Question about Marantz Audio Players & Recorders
...is gone and therefore the needle isn't holding to the grooves rather than a tracking weight or anti skate problem. [email protected] hi, take a WD40 spray it gently on the part of the
skip repeats halfway through Sounds like to much anti-skating with an old stylus. That can pull a needle back over and over again around the center of the record. Try setting the anti-skating at 0% ...
Anti-skate control set to low. First check the stylus you should feel it sticking in you finger a bit. 2 Has the weight on the end of the arm become lose? Adjust for the correct tracking weight of the
an odd record then skips a few grooves on a good condition record, you can adjust the Anti skate control to prevent it. Adjustment it is like setting the stylus pressure, a question of trial and error
276 questions posted
Usually answered in minutes!
325 Questions
185 Questions
116 Questions
103 Questions
97 Questions