Question about Kitchen Ranges
...stuck. The ignition is supposed to stop when there is a flame but dirt on the burner or ignitor affects the flame pattern and may cause it to keep trying to ignite. If the switch under the knob has ...
Question about Belling Kitchen Ranges
...stuck , push in and turn the control knob to the full on position (large flame symbol). If your hob has an ignition switch on the facia, press it in until your burner lights. • Hold the control knob ...
...stuck my knob will not turn the burner off, if I press hard it will strip the knob, the flame will not turn off, it remains on. I had to turn the gas off at the source Not knowing age - very often ...
...stuck you must remove a wire from each switch till you find that one This video shows how to adjust flame: Sometimes the burner holes get clogged. I use a toothpick to clean out the holes. Hope this ...
Question about Lofra Kitchen Ranges
...that start the spark when you turn the knobs on. One of those switches is bad and stuck in the on position. You have to pull the knobs off and remove the trim behind the knobs to get to the
Question about Kitchen Ranges
...burner is on. As far as the igniters continuing is concerned, there is a problem with one or more than one of the push in to ignite knobs being stuck in the in position. Use some CRC or WD40 spray on ...
...burner is lit. Burners light properly when the knob is turned to enable flow of gas, yet sparking continues non-stop. I have to disconnect the power to get it to stop. Model number of the stove is ...
...burner knob will not turn to on. Other three wokk normally. removed knob and put small wrench on shaft felt like it was stuck. don't bandy with the knob assembly have the entire valve replaced by ...
...burner knobs to "ignite" all FOUR burners will spark/click. This is normal. If you're getting a spark from the ignitors when all knobs are set to "off" then you most likely either got some moisture ...
help figure out why the burner spark keepson clicking... Gas Range Repair Burners Keep on Clicking heatman101 One of your switches is loose or stuck closed. The switch behind the knob must be replaced
206 questions posted
Usually answered in minutes!
58 Questions
56 Questions
38 Questions
41 Questions
42 Questions
