Question about Sears LiftMaster Building Materials
KEYPAD NOT WORKING. iT'S BEEN BELOW ZERO WINDCHILLS THE LAST 2 DAYS. WILL THIS AFFECT THE OPERATION? YOU DON'T EVEN GET THE BLINKING LIGHTS WHEN YOU PUNCH IN CODE. I CHECKED & THE WIRING IS INTACT
...code not the keypad. If the keypad doesn't even light up when you key in the code and press enter and you are certain the battery is good then the keypad has just failed and will need to be
...keypad doesn't do the same thing. I don't know the old code from the previous owner. Even after I pressed the SRT reset button on the opener to reset all codes, it won't reprogram. When I type in the ...
Question about Sears LiftMaster Building Materials
...even though you do not have lock button. If this has stopped light from blinking, you now have to code remotes and or keypad back in. Push the little buton for 1 second and push a remote. Light bulbs ...
Question about Sears LiftMaster Building Materials
...light keeps blinking even after resetting the opener buttons turned motor by hand it free and it tryed to run for a secound or two help. Is the blinking green light sending a code? Flash then pause ...
sensors only orange not green both sensor lights only go orange even if I put them right next to each other... I would say you have a bad logic board.
Question about Sears LiftMaster Building Materials
...even after putting in new bulbs, they do not light up. Help! Unplug the opener from the power and take a small screwdriver and pry out on the center contact in the light sockets. There is always the ...
...even if I follow the instructions. The keypad lights do not go off after the smart button is pushed, the code entered, and the enter button held. The keypad lights should blink after the enter button ...
Question about Sears LiftMaster Building Materials
I can't get my sensors to align please help, amber light stays on, can't even get the green light on opposite sensor to flicker You have a bad sensor.
Question about Sears LiftMaster Building Materials
even with new battery You can try programming but if it still doesn't work then your keypad is just bad. Locate the smart/learn button on the rear of the motor unit near where all those white wires go
5,971 questions posted
Usually answered in minutes!
0 Questions