Question about Sears LiftMaster Building Materials
...goes bad from constant use and the problem with the wiring is caused by the staples most installers use. The staples cut through the insulation and cause intermittent shorts. I would remove the wall ...
Question about Sears LiftMaster Building Materials
...goes in downward motion, will not shut off,or stop,just keeps going down, then you have to unplug it The thing to do is remove the cover and watch the limit switch assembly. You should be able to see ...
Question about Sears LiftMaster Building Materials
goes up but not down. The sensor lights are on and not flickering And are not dirty . I have to hold the door control button to make it go down. Any ideas? If you try to close, do light bulbs on motor
...goes back up. I replaced the sensors @ the sides of the door to no avail. I have tried to adjust the up and down on the side and rear of the motor to no avail. W could it be? I agree with the closing ...
Question about Sears LiftMaster Building Materials
motor unit is a small "learn" pushbutton. When you press it, an indicator light nearby comes on. Keep the button pressed until the light goes out (5 to 10 seconds) and all codes previously set will be
...goes into the garage. He is in his mid 80's and has demencia or something and moved down the street to his daughter's, so I don't complain. I just want to change the numbers for entry. The numbers on ...
Question about Sears LiftMaster Building Materials
...goes bad the door will start down and the logic board will not receive the electronic pulses and it will reverse. It is this sensor that causes the door to reverse when it runs into something. The ...
Question about Sears LiftMaster Building Materials
...goes on ( on the remote and on the opener in the garage ) but nothing else happens. The wired opener button on garage wall works just fine . The little button with a padlock on the wall control is a ...
Question about Sears LiftMaster Building Materials
...motor unit. I would do that for a night or two just to see. You can then go further to eliminate the wiring or the wall control. If you replace the wire on terminal #1 and then remove the wires from ...
5,971 questions posted
Usually answered in minutes!
0 Questions