Dewalt 18 Volt Compact Drill Kit "batterie works reverse" Questions

...works fine. The back to reverse and for the first trigger pull it will stay in forward. I release and pull trigger again and if will go into reverse mode. What is causing this. It has happened since ...

works fine in forward but will not go in reverse Hilti SF 121-A battery drill. the drill was working both in forward and reverse but now will only operate in the forward rotation. Assuming that it's ...

...before i recharge? Yes, three times. Run them all the way down.Then fully recharge Hi, Usually the batteries are needed to be recharged 3 times. But if the Nicad batteries are showing charging ...

...old thought of discharging completely is STUPID. The idea was to avoid a memory problem of NiCad batteries. The problem is one cell goes dead first and then the others REVERSE charge it if tool is ...

Craftsman cordless drill won't work even after charging battery. Try working the switches Low/High, Forward/Reverse. Sometimes, the battrey can hang up a bit in the charger, resulting in a low, or no ...

...reverse and when you press the trigger nothing happens. See Page 15 of this PDF for more information. 4. If none of this works, there is a Recall for that Battery Unit. Check This PDF to see if what ...

my 24v new makita drill doesnt hold charge the new batteries now have a little computer in them, so to speak. when you plug in the battery to the charger and you get the alternate flashing light the ...

...reverse. Worked fine - then suddenly stopped working. If you are sure that battery is fine, problem can be in the switch or brushes. I would check switch first - open the driver, take 2 wires and ...

I have 3 drills, (2)14.4 and (1)18 volt Dewalt. the 14.4 drills starT to smell of burning and then smoke. One of the 14.4 drills seems to be less powerful. The 18 volt hammer drill is stuck in forward

...works, the reverse switch does not move. You have burned out the drill motor, it is shorted, the battery smoked due to a direct short, one thing I don't understand why the thermal limiter didn't trip ...