...plastic retainer piece from just below top hinge on the door. Now lift the door gently and it will come off in your hands. Set aside and be careful not to let the loss bracket that passes into the ...
...plastic gear on the bottom is worn out and stripped. MAkes a clicking sound This problem is commonly caused by a turntable motor that has worn out and needs replaced. The following link explains how ...
Question about Kenmore Microwave Ovens
...top front plastic horizontal louvered front vent by one phillips screw on each end of the vent left and right. then remove the next two phillips screws you see under where the vent screws were. then ...
...plastic like smell) and am unsure what I can do from here. Any help would be appreciated. Not to worry ,Please use a good torch light or lamp to look inside the microwave cabin. On the side where the ...
...top vent exhaust grill has two screws facing down-remove these. remove plastic vent. inside you will see a solid wire tringle assy. turn and pull this release. warning if you have granite counters or ...
...plastic back and main body of door, start on sides and bottom and gradually unclip. Once the sides and back are clear the top should come away easily. Note the part by the hinges is very thin and ...
...plastic cover on the inside of the door. Work around the edge of the glass until the cover slips free. Remove the door by pulling the mounting pins out of the hinges at the top and bottom. You may ...
...plastic insert in place between the micro & oven, but you might want to remove the metal lip on the bottom of the oven to help prevent scratches to the cabinet. After that's done, get a helper and ...
...a regular one will work fine. Open the top cabinet door for a better angle, bend the plastic a little and you should have a clear shot at it. The bulb is nothing special its a g8 base 120v 20w
334 questions posted
Usually answered in minutes!
122 Questions
129 Questions
91 Questions
99 Questions
58 Questions