Kenmore 66312/66319 Microwave Oven "open turntable starts rotate" Questions

...turntable and magnetron once you open the door. you can trace the switch that runs the turntable. start from the power supply, goes to the door switch then to the controller before it goes to the ...

open the door, it starts on, the turntable continuously rotates. Could you please help me. It's probably a defective door switch, probably the upper one, or the mount which holds the switch is broken.

...turntable starts rotating as soon as the door is opened...stops when it is closed. It rotates when the unit is on and heating. Sounds like a bad relay?...is one is used for this purpose? It sounds ...

...Open the microwave door, and carefully remove the turntable tray. Also, remove the frame that the turntable is positioned on. Both the turntable and the frame are not secured in the oven, so removing ...

...turntable, guide and base plate. Try turning the motor to see if it's just stuck. If it doesn't turn freely after a few seconds, examine the motor to see if it's burned out or corroded. ...

...turntable motor.to chk this open up the bottom plate by removing the screws around it.then disconnect the wire connector from the motor.start the unit and chk the voltage with multimeter.if u read ...

...Open the microwave door, and carefully remove the turntable tray. Also, remove the frame that the turntable is positioned on. Both the turntable and the frame are not secured in the oven, so removing ...

open the door and using a small screwdriver, depress the micro switch you can see upper right side of the door opening. then press start again. your turntable will start turning and the microwave will

turntable now will stop running sometimes and a clicking sound starts. I can then open the door and move the items cooking a little, and it will start rotating and not clicking again for a few minutes

turntable starts rotating though a bit slower than when the microwave is heating. Please let me know the solution if anyone has seen this. Thanks! This is usually caused by a defective door switch, or