HP Compaq nx7010 Notebook "hard drive" Questions

hard drive removal how do you get the hard drive out to replace it?I cannot find it. Remove the hard drive Loosen the two Phillips-head screws that secure the hard drive cover to the bottom of the ...

...hard drive. It could be a faulty connection on the hard drive - try re-seating the hard drive. The hard drive may be faulty - go into the BIOS and see if the BIOS detects the hard drive. If the BIOS ...

...hard drive can't find hard drive If the laptop cannot detect the hard drive. This can be caused by a faulty disk controller, or a faulty disk drive. 1st. Reseat the hard drive and see if the laptop ...

Hard Drive Installation Instructions 40 gig IDE DRIVE Shut down the computer and remove Battery Pack and AC adapter. Locate Hard Drive compartment on the front panel, just left of the head phone jack.

...hard drive or the hard drive is faulty or the disk controller is faulty. Check the BIOS setting to see if it has detected the hard disk, and if there is a hard drive diags run it to test the hard ...

...hard drive not found Possible crash of the hard drive or the partition. Try and see to reboot and get the drive to work before confirming. to the BIOS configuration and see it the BIOS detects the ...

...hard drive has come unplugged. Or the hard drive might have died. your hard drive may be loose. remove the small access panels from the underside of the computer until you find the hard drive, it ...

hard drive Go to the BIOS configuration and see it the BIOS detects the hard drive. If it doesn,t detect the hard drive then the hard drive coulf be faulty. Another way to check the hard drive. Remove

...hard drive. Does the hard drive LED flash and the hard drive spin up when you bootup? If it doesn't then you could have a faulty hard drive or a fault disk controller. Reseat the hard drive to see if ...

...hard drive. This can be caused by a faulty disk controller, or a faulty disk drive. 1st. Reseat the hard drive and see if the laptop boots up. 2nd. Go into the BIOS configuration and see if the BIOS ...