Maytag Neptune MAH5500B Front Load Washer "washing machine tub move side" Questions

...washing machine is revving up to spin and dying down from a spin (suspension problems are also often worse at this stage too). It's not normally a metallic sound though. If the noise is coming from ...

...tub around after the washing it done. Perfectly normal..What you are actually hearing is a balance ring on the inner tub that has liquid inside to help keep washing loads balanced.The balance ring is ...

at spin cycle, the tub spins out of its orbit hitting the sides, then it stops moving with an error on the screen. this is a maytag neptune 7AV6800AWW Hi, When my washer did that, I found that the ...

...around inside. The drum moves around also. ok open the door make sure the thing is empty try to move the inner tub if you can shke it side to side anything but around you have a broken spinner ...

...tub to the back right corner of the machine the display should change to ?UO? (Unbalance open). Release tub and the display will show ?UC? (Unbalance Closed). 3e. Press Hand Wash. 3f. Pull tub to the ...

...move the wheel and I still get this clicking noise. It sounds as if someone is hitting the plastic drum that the tub is surrounded by. I really doubt it's the bearings this soon, as the sound is not ...

...tub bearing. This bearing is under a lot of stress and tends to wear out. Check and see if there is excess play in the drum. Move the drum all around. Also if you remove the back panel plate you can ...

...side there is a little shock that holds the tub stable. They looked good at first, but when I moved the tub around I could see that the loop on the end was broken off where the pin fastened the shock ...

...tub to move out of specs and then water splashes out. My machine sees normal use (4 to 6 loads a week) and is 6 years old. I paid $1200 for this unit because it is a Maytag, but never again. Repair ...

...tub is hitting the sides of the washer. Check to make sure the drain hose has no kinks. Push the machine a little and see if it scrapes or bumps anything outside the machine.( machines tend to move ...