Maytag Atlantis MDG7400AW Gas Dryer "pull start" Questions

start When I pull the knob out to start it doesn't start There is a door switch that not only turns on the light in the dryer, but also completes the circuit so the machine can start. Check the switch

...start button. To get to it, unplug the dryer and pull it away from the wall. There is a metal cover that runs along the upper rear side of the dryer -- remove that and you will see the switch behind ...

...pull to start My fridgiare dryer knob is pulled off, and when I put back in, I cannot pull out the knob to start. It seems I cannot properly put back in the knob. Any suggestion ? Model number is ...

...START YOU PULL OUT THE KNOB-WE HAD TO START PULLING IT OUT & TWISTING IT A LITTLE TO START-THEN IT STARTED DOING NOTHING.BELIEVE WE JUST BROKE THE KNOB Go for item 5 on this diagram. You can buy it ...

...start swith is momentry with the switch stuck you woild have to break the the conecton by pulling one wire off the switch and tuching the outher wire momentary do not conect if this works its the ...

...start. Hi, we have to almost pull the dryer knob off to get it to start. I looked at the parts diagram but not sure what is the part I should be ordering. can you help. Rick yeathe start switch is ...

...door is closed tight and the vents are clean. IF THIS MODEL USES THE TIMER TO START THE MACHINE BY PULLING OUT ON THE KNOB, I HAVE HAD TO REPLACE QUITE A FEW TIMERS FOR THIS PROBLEM. SOMETIMES BY ...

...start. i pull bottom, it makes a soft noise if i keep it pulled out and will not start. Hi, There can be many reasons why your dryer will not start or turn... The most common causes are the belt ...

...start dryer - must pull control **** VERY hard it has gotten harder and harder to start our dryer (maytag atlantis MDE7400AYW). we must pull the control **** out so that you can see the front panel ...

...start knob doesn't engage when pulled. Do I just need to replace the knob assembly? Is it difficult? Take the knob off and try using pliers to pull the stem. Don't pull any harder than you would with ...