...old card, and reconnected to the new one without difficulty. I had some trouble removing the connector that plugs in to the bottom of the card, I broke off the two tabs on the side of the connector ...
Question about Samsung Televison & Video
...old. 2. Suddenly, when turning on plasma, screen light up but looks like scrambled/fuzzy white snow 3. Have tested source - austar and standard signal is good (checked with another PLASMA). 4. have ...
Question about Toshiba Televison & Video
...wrong but sounds like your plasma display is going bad. What is your model number? only 18 months old, quit all of a sudden. Powers up but has no picture/no sound. Found a blown 4ah fuse on the ysus ...
...old. If I press the power switch the red standby lights for a couple of seconds the relay sort of click is heard then in stead of the tv powering on the standby light just slowly dies out? For around ...
...old - sound, but no picture. Cable tech thinks the "crystals" are bad (the equivalent of the picture tube?)Would this be worth fixing, or is it too pricey? If an LCD TV has sound but no picture ...
...wrong, sometimes it may indicate the "Area" just, say in your case, it was, say, in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days ...
...wrong, sometimes without actually "Seeing" the unit, sometimes a symptom, well, it may indicate the "Area" in your case, just say, it is the X board. BUT thats NOT where the "Fault is" thats just the ...
Question about Hitachi Televison & Video
...old) screen separation and now the 32" LCD 1 just a month after 1 year warranty with no picture. Will fix but never buy Hitachi again hi, try these steps... Use the source button to ensure that ...
...wrong, sometimes it may indicate the "Area" in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days unlike the "Old" analogue days it just ...
Question about Samsung LN Televison & Video
...wrong, sometimes it may indicate the "Area" in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days unlike the "Old" analogue days it just ...
339 questions posted
Usually answered in minutes!
357 Questions
270 Questions
256 Questions
175 Questions
155 Questions