LG WM2688HWM TROMM SteamWasher "trouble heavy loads" Questions

...heavy soil level, with no clothes, and a washer cleaner such as Affresh, Washer Magic, Whirlaway hot tub cleaner, Smellywasher cleaner, or Tide washer cleaner to remove any possible build up of soap ...

...trouble My LG WM 2277HW will not spin during the rinse cycle. I also get an O.F. or O.E. message???? PLease help. take off the front kick plate on the bottom and there is a pea trap thats conected to ...

...heavy duty cycle but not the permanent press cycle. If you have access to a clamp on amp meter, see the image below, then you can check the amp draw of the washer. The washer normally will draw about ...

...Trouble shooting steps for LE error on WM1832CW: 1. Open back of the washing machine and control panel. Locate two wire harness coming out of main motor and main board. Check the wires for any cuts ...

...type either with the round dial in any mode other than heavy or bulky. please go tp the manufactures website and download the user manual its normally free and look in the trouble shooting section ...

...heavy to spin if you drain the wasger and put towels in on Sin Only it works Washing machines have trouble if they are overloaded and the load gets out of balance. This occurs most often with towels. ...

Trouble getting spin cycle to work properly It seems to wash and agitate ok, but you have to put just the right amount of load in washer to get it to spin. Too heavy or too light of load will make it ...

...trouble with the spin cycle. We have to help it start then close the top & it will continue. If it's a heavy load such as towels it's leaving more moisture in the towels than usual. It's ...

...trouble shoot? I plugged and unplug it didn't help we had our water source fixed while I am washing closthes but i did not cancel the washing cycle at that time. Now it displays E11 error code. What ...

...can drain/spin, but it will not unlock. I think I overloaded (heavy duvet cover)and that may have given it trouble. Now what? thanks for any advice. Unplug the power cord let it reset..It should ...