...Spin Only to remove any remaining water from the washer. The door should unlock at the end of the cycle. Is the door locked and the Add A Garment light on? If the Add A Garment light is on, then the ...
Question about Whirlpool duet Washing Machines
...run the drain cycle several times. It keeps staring and runs for a few minutes and then stops and resets itself and starts up again. I almost seems like it can't get the load balanced. I am not over ...
...Spin Only to remove any remaining water from the washer. The door should unlock at the end of the cycle. Is the door locked and the Add A Garment light on? If the Add A Garment light is on, then the ...
high efficiency detergent and run on the Normal/Casual cycle. I followed these directions as written. The bottom of the drum filled with water, there was some clicking like when the washer is supposed
run a drain/spin there is is one blanket and no soap, the cycle starts with draining and then the SUD error comes on for a few min. the the cycle starts agian w/ draining and then the F 02 error comes
Question about Whirlpool duet Washing Machines
...spin at a high rate of speed to allow for the clothes to spin dry therefor the door latch will not open. The F33 error indicates a PUMP DRIVE SYSTEM ERROR and occurs when the connection between pump ...
Question about Whirlpool duet Washing Machines
high efficiency) rated detergent in this washer. Your washer uses less water than traditional machines. With less water, the wash action can create too much sudsing when regular detergent is used. The
Question about Whirlpool duet Washing Machines
...high-speed spin the door will be unlocked after 3 minutes. Potential Causes: * Check wire harness connections between the Drive Motor/Tachometer and the Motor Control Unit (MCU), and between the MCU ...
Question about Frigidaire Washing Machines
...high spin if they detect that too much soap is being used. Also if you go to the spin cycle, click cancel TWICE to where the lights are lit up again then hold down the START and the OPTIONS button at ...
Question about Maytag Washing Machines
...twice. The door will not immediately unlock while the cycle is running due to a possible high-water level in the washer, high-water temperature, tumbling or spinning. It may take up to five minutes ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions