Whirlpool LER5636P Electric Dryer "heating air" Questions

...from the incoming air the dryer should then stop heating, draw unheated air through the drum and clothes to cool, and reduce wrinkling then switch off the dryer appears to be operating ...

...and thermistor Air flow good If your heating element is grounded (wire burnt in half and is touching metal) the heat will stay on forever, even in air fluff. This is your most likely

the dryer doesnt get hot enough to dry clothes Pull the dryer out and remove the lint hose . Turn on the dryer and feel if there is good air flow and if you feel heat . If there is good air flow and ...

...Air Dry cycle on your appliance is heating up instead of using only cool air, there could be several possible causes. Here are a few things you can try to troubleshoot the issue: Check the controls: ...

...air path is lint free. I'm pretty sure now the heating element needs replacing. How do I take dryer panel(s) off to replace the heating element? Other info: FYI: In the past I had a Kenmore, the ...

...heating element is working but my clothes still won't dry clean out lint filter check the vent hose make sure you are getting a air flow out your vent hose if not its blocked inside no air no dry ...

...Remove the back of your dryer and located the air tube that goes from the blower to the drum. Normally inside the air tube you will find the heating coil and the thermostats. I hope this ...

maytag lde410 dryer air blows but is not heated. drum turns and air blows -- as ''normal'' -- but air remains room-temp The heating coil may be broken, or the heat sensors may be malfunctioning.

...air fluff, I see the heating element cycle on for a 15-30 seconds and them off for a minute or so and then repeat. So the heating element is not shorted. A small amount of lint was cleaned before the ...

...dryer isnt generating heat.. Check for proper air flow Test the safety fuse Test the thermostats Test the centrifugal switch Test the timer motor Test the heating element. Thank