HP PSC 2175 All-In-One InkJet Printer "scanner belt motor stop" Questions

...scanner light? For tech guys only: Remove ADF unit, remove control panel bezel, remove flat bed screws & take out flat bed cover(glass), detach CCD cable & belt take out CCD unit, Remove ...

...belt, scan head) and turn over. 6) Thoroughly clean all glass and mirrored areas of the scan head. Also clean the scan lamp on the top of the scan head. Clean the tray inside the scanner (where the ...

...scanner starts its check and does not stop(keeps trying to go farther to the right).After about a Minute of clicking,(from the drive belt slipping) all the lights flash,then even the printer is ...

...Belt pressure/retraction failure C0098 Fusing Pressure Roller pressure/retraction failure C0200 Cyan PC Drum Charge Corona malfunction C0202 Magenta PC Drum Charge Corona malfunction C0204 Yellow PC ...

...Belt pressure/retraction failure C0098 Fusing Pressure Roller pressure/retraction failure C0200 Cyan PC Drum Charge Corona malfunction C0202 Magenta PC Drum Charge Corona malfunction C0204 Yellow PC ...

scanner gets to the end, it will not reverse. The motor will still run, but the gears will make a stripping noise against the belt just unplug the cord for 15 minutes .....and it will reset .... Go to

...scanner head, de-tension the belt by moving the white leaver at the back right (on the "floor" of the scanner bed). by slightly lifting the leaver you can detension it a lot. Now remove the belt from ...

...scanner light carrier and there is a noise caused by the belt, because electrical motor is trying to reach the stop.This noise lasts for around two minutes and after that it stops, all the lighted ...

...Scanner error occurred...Please see documentation. The owner's manual has no such "documentation." I tried turning off the printer for a while to see if it might reset itself, but that ...

...belt to move the scanner bulb assembly towards the left side as far as you can go. Then, turn the machine off and on. If you are adept at printer repair, remove the right side cover, by removing the ...