Canon PIXMA iP5000 InkJet Photo Printer "error code 5 mean" Questions

error code 6000 Error 6000 is a line feed error, it means the platen roller isn't advancing properly. It usually means something has fallen in from the back where the paper goes and is stopping ...

...error code 1401) or the EEPROM data of the print head is faulty (error code 1403 or 1405). Make sure the contacts on the printhead are clean, re-install and try again. If this fails a new printhead ...

error code 6000 mean? That is a line feed error (6000) It also should be flashing 3 times for this error on the on/off button. This could be 1. Timing sensor unit QM2-2683 2. Timing **** disk film QC1

...error code is a logic board error code. The PCI Bus error is detected by the ASCI. Sounds like it needs new logic board. but i suggest you to first of all you can try to reset your printer - 1. Turn ...

error code E 5 PLEASE TELL ME WHAT DOES THIS CODE STAND FOR THANKYOU GOD BLESSREV. PM LUYT This means that the ink cartridge may not be compatible or may not be installed correctly. It also may just ...

...error code e13 on cannon pixma mg3122 Cannot connect IPad to cannon printer scanner E13 means that the printer cannot detect the ink level. Press and hold the 'Stop/Reset' button for 5 seconds to ...

...Error Code means that your Printer didn't detect the Ink Cartrigde. It sometimes happen when you are using a non-original cartridge or infusing it. When Canon Printer detect this abnormality, then ...

...Error code E2-2 = No paper (ASF) E3-3 = Paper jam E4 = No ink E5-5 = The ink cartridges are not installed or a non-supported ink cartridge is installed, or the ink cartridges are not installed ...

...5" flashing (back and forth between them). I've lost manual, so I'm not sure what they mean. I'm pretty sure the "E" is simply for "Empty" since the "Black Ink" and "Color Ink" cartridge lights flash ...

...error code 1401) or the EEPROM data of the print head is faulty (error code 1403 or 1405). Make sure the contacts on the printhead are clean, re-install and try again. If this fails a new printhead ...