dr-2050c multi-page document stops scanning after one or a few pages, inconsistently. Feed lever is down in the multi-page position. Feeder tries to separate the pages: sometimes it succeeds. Document
Question about Canon DR Office Equipment & Supplies
...page was found in the feeder'. Added another 25 pages, begins to scan then stops after the 3rd page. Tried using the 'Count Only' feature and have the same ...
Question about Canon DR Office Equipment & Supplies
dr 5010c feeds one to five sheets, then stops dr 5010c feeds one to five sheets, then stops scanning with paper in the bottom read unit and one sheet about one inch from the exit roller area. Error ...
...a dialog box asking to continue or stop scanning. This is a known problem with the scanner. Use PixEdit to scan which comes around this problem so the scanning terminates OK after the ADF goes
Canon DR-2050C Skip Blank Page Error Scanner has stopped working when Skip Blank Page is selected. It only scans the front side. If front side is blank it gives the error that there is no paper in the
stop and start between pages when scanning with Adobe X If the target storage area is insufficient this will happen. Clear disk space, run 'defrag' to make space contiguous and try. Also if you choose
...Errors. This will stop VRS from flashing the out of paper message. (Also, ImageNow has it's own prompt when the scanner is empty. You can turn that off in the Scanning Profile on the Properties
...the display screen asking to stop or continue Try reinstalling scanning software. If one of the DLL files are corrupted, this can happen. Also run Scandisk of your hard drive. S. Mohan, Chennai, ...
Question about Canon DR Office Equipment & Supplies
scanning) has no problems. I think there may be a problem with the image processor on the mother board, but I don't know where to buy the motherboard to replace it. Do you have enough hard disk space?
Question about Canon DR Office Equipment & Supplies
...STOP scanning. I'm getting a SCAN panel. At start get into settings and change to Portrait. (If you are not able to get into settings, uninstall CP3, restart the Comp and reinstall the software.) You ...
216 questions posted
Usually answered in minutes!
58 Questions
64 Questions
33 Questions
38 Questions
28 Questions