Question about Canon DR Office Equipment & Supplies
My Canon Dr-9080C isnt pulling the paper into the scanner. The input try elevates, and then returns to it's original position, without the paper being pulled into the scanner, as if there wasn't any ...
...paper sensors are located along the center of the paper path. They are: Registration (lever type) on the bottom between separation & registration. Look for lever damage or torn paper. Scan Start ...
Question about Canon DR Office Equipment & Supplies
Error P00 on display, no paper jam found have a canon dr-7580 showing a P00 error code on the display - paper jam. Have checked and ther is no paper jam in the scanner. Error will not clear. How can i
sensors. They should be somewhere along the paper path, and consist of a plastic lever that will be pushed down as the paper moves past them. Usually these levers have springs attached - if the spring
Question about Canon DR Office Equipment & Supplies
...jam found? iDoc scanner has a error when no paer jam found??? There are sensors in the paper path. Just blow air to ensure that there is no shreds of paper is blocking the sensor. S. Mohan, ...
Question about Canon DR Office Equipment & Supplies
...Used also the Canon Diagnostic software "DRUnificationTool" but see no errors, only the "tray Unit Paper detect" Sensor seems be active all the time. It sounds like you diagnosed it. The tray "paper ...
...of the position the tray has to go down on powering on. There is HP (Home position) sensor for the paper tray, under the tray. Check if it is okay. Also in the middle of the paper tray, there is a ...
Question about Canon DR Office Equipment & Supplies
...have a Canon DR-9080c scanner that sounds like it is working, but the lifger will not lift up with paper on it. It then says no page found in feeder. Thanks. There is a paper sensor just under the ...
No image after scanning I put a document in to scan and it says paper jammed because the scanner continues to roll even after the end of the page, and no image was displayed The paper sensor must be ...
...paper sensors in any scanner. If one of them is blocked by a shred of paper, the scanners 'assumes' the paper is available and starts scanning. Try to blow air and clean the scanner. Take care not to ...
216 questions posted
Usually answered in minutes!
58 Questions
64 Questions
33 Questions
38 Questions
28 Questions