...exit ip route 0.0.0.0 0.0.0.0 192.168.105.1 spanning-tree Always turn on Spanning Tree spanning-tree priority 0 This switch is the master Spanning Tree operator. password manager password ...
...IP address of youe switch you need to look at your DHCP server ( possibly your router/modem) and see what addresses have been issued. Once you have found the address it is a simple task to open your ...
Question about HP ProCurve Computers & Internet
...the HTTP service from my pc. what's the switch port I have to use?. What's the subnet ip for this switch, I have to set in my pc to connect. Default ip: 192.168.1.1 user name: manager password: ...
Question about HP ProCurve Computers & Internet
...IP address the next time you switch them on) - Ideally You need to set a Fixed, Unique, IP Address, Subnet Mask, and Default Gateway, on each of the printers, using the control panel on the printer ...
...from my pc. what's the switch port I have to use?. What's the subnet ip for this switch, I have to set in my pc to connect. put a 192.168.1.1 in browser with default user id: manager password: ...
...ip address to a at-8624t How to Configure the Switch Some configuration is necessary to enable the switch?s advanced switching capabilities. This is achieved via the Command Line Interface (CLI). On ...
...switch Hi there, there is no real configuration settings for switchs as they are generally considered "Unmanaged Devices" and have no managment interface, if your using this device to connect 2 or ...
...ip helper . in config mode. Just configure your 4 scopes on your DHCP server, and as long as your server is VLAN tagging and the trunk between the gateway and the switch is dot1q then it will
IP address and other management features. I could not find a section on reseting the switch to factory defaults, so you may have to contact their support staff for that. http://www.symbol.com/category
35 questions posted
Usually answered in minutes!
9 Questions
4 Questions
5 Questions
