Turn the printer off. 2. Push and hold down the Select and Return button if it has them....and turn the power on while holding them down......wait until it says Reset PC Count...then push select....it
Question about Lexmark E Office Equipment & Supplies
...shows CONFIG MENU again, turn the printer off. 9. Turn the printer on (do not hold any buttons down thi time). Printer is reseted. I hope this simple steps will be helpfull for you. Good
Question about Lexmark E Office Equipment & Supplies
...MENU again, turn the printer off. 8) Turn the printer back on. (Do not hold any buttons down this time). The printer is reset. You can confirm the counter was reset by printing a ?menu settings
Question about Lexmark E Office Equipment & Supplies
...turn off the printer open the front cover press and hold the continue button turn on the printer once the error light is solid release the continue button close the front cover. press the cancel ...
Question about Lexmark E Office Equipment & Supplies
...off. 8) Turn the printer back on. (Do not hold any buttons down this time). The printer is reset. You can confirm the counter was reset by printing a ?menu settings page?. Fehler: Weniger Toner nach ...
Question about Lexmark E Office Equipment & Supplies
...turn shaft to pick paper up if latter not a easy job if you have not stripped a printer the cover has to come off gearbox needs to be reomeved very carful taken this off se how the cone clutch comes ...
...turn that off? Quite mode OFF is the default factory settings. To reduce noise produced by the printer, quite mode need to be turned ON. This will reduce the amount of noise but this will set the ...
Question about Lexmark E Office Equipment & Supplies
...turn off the printer, then open the front cover like if you were to take the toner cartridge out. Once the front cover is open then push and hold the two buttons on the panel of the printer and turn ...
Question about Lexmark E Office Equipment & Supplies
...Turn the printer off. 2. open the front cover 3. hold down the cancel X button while turning on the power and keep holding down until all lights stop flashing. Then let go of the x button and all ...
...turn it on there's NO SOUNDS and all the lights are RED. Have turned OFF/ON and UNPLUGGED/PLUGGED BACK IN. No change. This problem may be caused by the printers' system board. I suggest you ...
272 questions posted
Usually answered in minutes!
171 Questions
106 Questions
83 Questions
56 Questions
79 Questions