Lexmark X6150 All-In-One InkJet Printer "fix sticky rubber" Questions

...sticky, Clean the area until all ink is removed, you will use many cotton balls, continue until clean. Check the carrier parked area. You will note 2 rubber boots, 1 for each ink cartridge, make ...

...rubber bar, also you will notice the printer cartridges moving to the side as you open the lid of that printer. If the cartridges did not move back to the one side, it means that the guidance rod is ...

...fix: take the paper tray out, turn the printer on edge and locate those two rubber roller bands on the pickup arm. Peel them off, flip them inside-out and return them to the rollers. This restores ...

...fix.jpg Oleg Andrukh IT Specialist PhillyCopiers.com 215 364 3774 Here is the link for instructions from the brother FAQs for this machine. It has instructions on how to clean the rollers: ...

rubber roller is not moving properly and paper get crumbled its could be reason for gear is not driving roller properly or roller itself may be sticky or dusty if its not appear on top area and jam at

...the tape and glued in a piece of hard rubber of the same thickness. (Tape is only a temporary measure as it can compress or become sticky after a while.) Everything is back to normal now! Good

...sticky due to the soaked sponges and not returning to its original position. After that I didn't get the error message anymore. The two sponges on my printer purge station were black and possibly ...

...sticky and gooey). I saved it. Is it possible these were rubber rollers that have degraded over the years? Can these be replaced? Or does the copier just need a good cleaning? What's the best way to ...

...fix the problem. Solution for paper jamming. 1. Make sure the paper installed were shake off well to insure no sticky paper feeding. 2. Always Clean the rubber roller to free from dirt that causes ...

...rubber pad below may become sticky and retain the rocker, causing extra rotations. Slip a bit of Scotch tape over the sticky pad. A weak spring may not push the rocker up reliably. I cut a "U"-shape, ...