Tappan TGF320 Gas Kitchen Range "probe rtd" Questions

...RTD Sensor Probe. Check Sensor wiring harness between EOC & Sensor Probe connector. 2. (F30 or F31) Check resistance at room temperature, if less than 500 ohms, replace *RTD Sensor Probe. Check ...

...& compare to RTD Sensor resistance chart. - If resistance does not match the RTD chart replace RTD Sensor Probe. - Check Sensor wiring harness between EOC & Sensor Probe connector. Hope

...RTD Sensor Probe. Check Sensor wiring harness between EOC & Sensor Probe connector. 2. (F30 or F31) Check resistance at room temperature, if less than 500 ohms, replace *RTD Sensor Probe. Check ...

...RTD sensor probe/ wiring problem. Note: EOC may initially display an "F10", thinking a runaway condition exists. 1- Press Cancel key. 2- Check wiring in probe circuit for possible short or open ...

...keypad, electronic oven control board failure or the oven sensor probe (RTD) may have gone bad. It will either have a bad oven sensor probe (RTD) or a failed Electronic Oven Control (EOC)

tested ohms on switch an proved continectivity ??? The RTD sensor is the temperature probe that sticks into the oven cavity. At room temperature, it should have a resistance of about 1080 to 1100 ohms

...RTD Sensor Probe. Chck Sensor wiring harness between EOC & Sensor Probe connection". I had no way to troubleshoot all of this or even to know where to look for the RTD probe or the wiring harness ...

...RTD probe) connection. Check the temperature sensor and the wires and plugs between the sensor and the EOC are good, replace the temperature sensor (RTD probe). If the sensor and wiring are good, the ...

...probe. Hi mcifaretto, F3 code error indicates a bad oven temperature sensor (RTD). To fix this error, Check sensor harness and harness connection between oven sensor and oven control. Replace oven ...

fed367cebe model Oven control shows F3 when running ,sometimes says f1 You have a defective RTD sensor probe or a bad wire connection to the probe.