jumper setting (Master, Slave or Cable Select). Then look again the rear side of the HD and u will see some pin that locate beside the power input of the HD, that is the jumper pin. Now set the jumper
Question about Maxtor Computers & Internet
...setting in the jumper area, which is between the data plug and the power plug on the back of your HDD. main thing that will cause drives to not work is 2 jumpers on the same cable and they both are ...
jumper setting is done for maxtor n256j50 If this is an IDE/PATA hard drive then the jumper settings are marked on the circuit board. MA = master SL = slave CS = cable select If this hard drive is the
...jumper setting for model 6v200e0 Need to know maxtor hard drive jumper setting for model 6v200e0 (Serial ATA) here is a poster of Maxtors jumper settings for each kind of drive. Serial ATA drives ...
i need jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on ...
Jumpers Serttings on Quantum HD Where are the jumper pins and what are the slave settings. Only jumper I found has ..CS..DS..and SP. Right now the jumper is on the DS pins. Thanks! Nick CS = Cable ...
Question about Maxtor Computers & Internet
gig hello go to this link.. it will illustrate jumper setting http://sysdoc.doors.ch/MAXTOR/diamondmax_30_vl_ultra_ata_66_quick_specs.pdf This link should help. Maxtor Basic jumper settings: Good luck
Maxtor hard drive jumper settings for model 7245At maxtor hard drive jumper settings for model 52049h3 1. Jumper settings for model 7245At refer to LINK 2. jumper settings for model 52049h3 refer to ...
JUMPER SETTING.WONT GO INTO STANDBY MODE, REBOOTS ITSELF Set The Jumper Setting On Your Hard Disk DriveThe hard disk drive will be detected as 32 GB if the jumper is set to the 32 GB clip pin setting.
...jumper setting to run my hitachi 250 gb sata laptop hdd as a slave ? There should be, look on the rear of the drive, close to the SATA and power connectors, you should see the jumper connections as ...
51 questions posted
Usually answered in minutes!
736 Questions
430 Questions
332 Questions
330 Questions
306 Questions