Question about Pontiac G5
...sensor replaced intake and exhaust cmp actuator solenoid replaced maf sensor after 2 days car is missing surging and shutting off Have the codes read first. Then take it back. This way they wont ...
...sensor input informs the PCM. At idle the voltage should be 1 to 1.5 Volts and approximately 4.5 Volts at Wide Open Throttle (WOT). The PCM looks for any change in manifold pressure to be preceded by ...
...sensor on the rear exhaust manifold on top and that will solve your problem, hope this is helpful. Hi there, P1150 Air/Fuel Sensor Circuit Range/Performance. (cylinder bank 1 Sensor 2) P1150 may mean ...
Question about Cars & Trucks
...exhaust. Sensor Two is positioned just after the catalytic converter sticking sideways out of the exhaust pipe. Sensor One will be positioned nearest the engine, between the exhaust manifold and ...
...sensor mounted in the exhaust manifold. If it is a V-6 engine, it will be in the rear exhaust manifold (between the engine and the firewall). Since it is an OBD1 vehicle, the computer ...
exhaust valve control solenoid P0047 - Turbocharger/Supercharger Boost Control A Circuit Low This vehicle is not equipped with a turbocharger or supercharger if it is a 1994. P0137 - o2 Sensor Circuit
exhaust can cause the sensor fault you have been getting if their is no fault with the exhaust then change the sensor and this should then solve your problem. Let me know how you get on or if you need
Question about Buick Cars & Trucks
...exhaust then goes to catalytic converters. If you have two, there is a sensor after each one. These are the downstream sensors. Before replacing a sensor, uou should determine if it is bad. Trouble ...
...may be the problem. Can anyone offer any suggestions. Thanks much. exhaust leak before the sensor because if was after the sensor it would not pickl it up so there is a exhaust before the ...
...or somthing else run fault codes as there are a number of sensors that will put that light on from the exhaust (o2 Sensor- cat converter-leaking inlet/exhaust manifold) to canister control
8 questions posted
Usually answered in minutes!
216 Questions
93 Questions
26 Questions
4 Questions
4 Questions
