2011 Ford Ranger 2.3 "power coil spark plugs" Questions

...getting from the coil to the distributor and then to the spark plugs. You can use a VOM or Test Light (whatever you used to check power to the coil) to determine where you are losing spark. Good

...coil getting power,and sending power to the distributor? you can run a jumper from the positive battery post to the coil and check for spark, need to see if coil is good, you said it was arching off ...

...coil...? If so check batttery power at the end of two wire that connect to the coil. (When car is still on ) Q: Any voltage...? A: Yes.>>> Bad coil. Replace new one. A: ...

...power to the coil pack but not to the spark plugs, and you've already made sure to check your wires and fuses/relays, then it is probably a problem with your coil pack. The ignition module on my 1990 ...

...coil pack have power to it, put new one on still no spark Have you checked the spark plug its self. You can try to see if it sparks to ground. To do this try to touch it to the engine block while ...

...one wire at the time and have someone turn the engine over while I held the wire with a rubber tool and there is no blue spark from either 4 plugs Do you have power to the coil from the EEC relay

...Also double check your connections at the starter to make sure they are clean and tight. Loose connections can draw extra power and could draw enough extra power to kill the coil. Hope this

...coil pack has power coming into it? And what else should i check and how do I check it? The Computer sends signal to the coils which sends spark to the plugs. u need to check for a code with a ob2 ...

87 ford ranger 2.2 litre No Spark new coi, new module, new spark plugs and wires but no spark from coil ??? Do you have power to the ignition module and a good ground?

...power on the - side of the coil with the key on and engine off. Crank the engine while watching the test light. Get a flashing signal at the test light when cranking? If so and you have no spark the ...