Zebra ZXP Series 8 Thermal Card Printer "printer ribbon error code" Questions

...printer The ribbon I had installed (code 061627) which says it is the correct one is in fact not. the drive pin on the printer slips while feeding the ribbon. I have fitted a (code 062471) and now it ...

...ribbon to. The printer will give a 754 error unless you have two plastic cores on the two spindles. It can also give a 754 error if the ribbon is not loaded properly, and also if you have a bad ...

...ribbon cartridge contains a chip that the printer must communicate with. If it cannot communicate with the chip, it will not work and you get the error message. The most likely cause of failure is a ...

...Ribbon Error" in B-372-QP Model of TEC make Thermal Printer. We have checked the following points. 1) Cleaned the Ribbon Path. 2) Cleaned the Ribbon Sensor 3) Replaced the Ribbon. Eventhough we get ...

...ribbon back inside, the printer accepted it until it ran completely out, and the new ribbons were rejected (all due to barcode damage). I inspected the barcodes, and if there were some of the black ...

...ribbon cables off the main circuit board. 4- Plug in power source and turn printer on. Wait till you get a error message and push "Ok". 5- Unplug power source. 6- Reconnect the flat ribbon cables by ...

...printer. I thought it was easier to print some labels. PLZ HELP ME MY PRINTERSays paper is out says ribbon is out. Both are loaded properly. Says head is open. It's not. Turned off and on. ...

...ribbon out Printer Idle: 60-16-3z after we moved it from a different location. However, we've been printing fine w/o ribbon for many years. so u used the direct thermal label that doesn't need a ...

...printer. A long plastic ribbon has come loose from inside the printer and I don't know how to reattach it. The ribbon has a letter "L" on the left side. The ribbon connects to a spring on the left, ...

...printer. Remove the ribbon and wipe the two lenses of the ribbon bar code sensor with a lint-free cloth or cotton swab. 2. Install the ribbon and power on the printer. If the message appears again, ...