watts only You can turn down VR18 which is your low power but as you turn it down your high power may go down also. If that's the case then you have to adjust L40,L42,L43,and L44 . If you don't have a
Question about Galaxy Radios Radio Communications
...an external watt meter and an alignment diagram. Go to www.cbtricks.com , look up Galaxy, dx939 and click on the radio alignment and it will tell you which variables to turn to get it back to 4
Question about Radio Communications
turn the watts up the meter drops and the radio shuts down? I can turn it off and back on and it works again till i try to turn the rf power up ' then it shuts down again ? you are probably heating up
...I seen get up to 40 watts peak, normally I would turn the audio pot up all the way never snip anything and deadkey down to 2 watts. Than adjust for forward swing, I also never run a pwr mic. Good ...
Question about Connex Radio Communications
...turn for lowering the watts on my connex it is too high and i would like to turn it back also the modulation thanks You have to adjust the high key first so make sure you're rf power is on high, hope ...
...watts wgat do I turn to accomplish this I doesn't seem to have much modulation either The radio needs to be tuned for the box. 3 watts sounds too high for a 2x8. I would say it would be more like ...
Question about Galaxy Radios Radio Communications
...watts but needle reflecting back swing my swr is 1.2 There are a couple of reasons this could be happening #1 and the most probable one is that your watt meter only reads RMS instead of PEP or #2 you ...
...turn the dead key down to 1.5 watts Then put a 40 watt modulator in line with a 400 watt amp. You will have an out put of 800 watts to the antenna. Make sure you have an antenna thats rated for it. ...
...watts , even when the box was turned off , i would turn off the radio for a few minutes and the modulation would return , then it would start to to drop and would lose modulation again, does anybody ...
more power rf tune up power turn it down to 1 may 1.5 watts and turn modulation up 95% and add a 500 watt liner to it and you are in business.
999 questions posted
Usually answered in minutes!
274 Questions
141 Questions
137 Questions
112 Questions
75 Questions