Question about Cobra Radio Communications
...NEEDLE DOES NOT MOVE ON TRANSMIT IN S/RF,SWR OR CALIBRATE BUT RADIO TRANSMITS GREAT.. HOW DO I GET THE METER OUT TO REPLACE IT try blowing some canned air on the knob and switch to remove dust , also ...
Question about Cobra Radio Communications
...needle wont move to the right to set whe trying to calibrate on cobra 29 ltd classic new radio You have to press the transmit button to get the radio to send a signal that you can calibrate the SWR ...
...where it won't break anything. If there is zero calibration slot by the meter try turning it. If all else fails you'll likely need to remove the cover and see if you can get at the needle. good
...it was the mic so i bought a new one but that didn't fix it. i took notice that when i tried to calibrate it the needle didn't move Are you certain that cb/pa switch is not in pa
Question about Cobra Radio Communications
needle will not go to the right make sure you have your radio set on CAL and then adjust the knob that says adjust .Turn it all the to the right then bring it back to the set point on the dial then un
needle should move up slightly if antenna is tuned correctly. Try chaneel 1 and 40 with same procedure. You can tell if antenna is tuned more toward the high or low frequency by how high the needle is
...needle up to the V cal spot. i had to turn the SWR knob all the way up almost to reach the V in the meter. so........after i done this i switched down to swr and they was wayyyy to HIGH ! almost in ...
...SWR control to CAL, key or press PTT, while pressing PTT rotate ADJ knob until max deflection of needle on meter, release mic, switch control to SWR, key/press PTT, needle reading/deflection is
...needle bounce even though you can't hear anything? If the meter DOES swing and you get the TX light, plug in an external speaker to the back (there's a spot marked for this, be sure to plug it into ...
999 questions posted
Usually answered in minutes!
274 Questions
141 Questions
137 Questions
112 Questions
75 Questions