Question about BenQ Office Equipment & Supplies
lamp cover and now it just has three orange flashing lights for the power/lamp/temp indicators. Help! Is there a way to reset? Nothing comes on--not the lamp or the fan. you can go to the BenQ website
...lamp/cover blink red The sony project lamp/cover blink red without giving out any light When I plug the LCD the LAMP/COVER flsh blinking red light My Sony 3LCD projector lamp/ cover flashes 2 times ...
...LAMP COVER HAS NOT BEEN REPLACED PROPERLY. AFTER PUSHING IN THE LAMP SCREW IT DOWN THEN YOU ALSO HAVE TO REPLACE THE BLACK COVER AND SCREW IT IN AS WELL, I ASSUME IT IS BLACK ON ALL MODELS, THEN I ...
Question about Sony Office Equipment & Supplies
...red light all the time Are you sure the lamp is pushed in far enough and did you make sure you screwed cover back on tightly? THE COVER MUST BE PUT ON OR THE RED LIGHT WILL CONTINUE TO FLASH S STAND ...
lamp LAMP/COVER Light on and the stand of the projector is not working .Lens cover opens LED in the top power LED Turns green and then goes red flashing and the lens cover closess Sent to V3 SYSTEMS &
Question about Sony Office Equipment & Supplies
...and fan and still have a flashing red light changed my lamp on my 50"grand Vega and got one or two flashing red LEDsforgot to put the lamp cover back tried again everything is fine now thank
Question about Sony Office Equipment & Supplies
...is it is flashing red. Please make sure lamp cover is reinstalled securely after replacement of lamp in TV. If lamp cover is not fixed properly, TV wont power up and red light will start
now will not turn on. Red light flashing on front switch panel. If the red light flashing 3 times the pause and again flashing 3 times, check and make sure lamp cover is installed correctly back on tv
lamp cover because under the lamp cover it had a safety switch if this SW not active then the unit will be in protection mode I sugges you to remove again the lamp and reinsert properly and secure the
Question about Optoma Office Equipment & Supplies
...this fault can occur. 1. Use a screwdriver to remove the screw from the cover.(1) 2.Push up and remove the cover.(2) 3. Remove the 2 screws from the lamp module.(3) 4.Pull out the lamp module. (4) ...
7 questions posted
Usually answered in minutes!
94 Questions
59 Questions
55 Questions
35 Questions
28 Questions