now will not turn on. Red light flashing on front switch panel. If the red light flashing 3 times the pause and again flashing 3 times, check and make sure lamp cover is installed correctly back on tv
...lamp cover, typically located on one of the rear corners of the projector's underside. Depending on your projector, you will either have to loosen a few Phillips screws or press on one or two ...
lamp cover because under the lamp cover it had a safety switch if this SW not active then the unit will be in protection mode I sugges you to remove again the lamp and reinsert properly and secure the
Question about Hitachi Office Equipment & Supplies
...3 year warranty so it may still be covered if the fault is not the lamp. Check now, and log the (possible) fault with your local Hitachi service dept. eg ...
Question about Optoma Office Equipment & Supplies
...this fault can occur. 1. Use a screwdriver to remove the screw from the cover.(1) 2.Push up and remove the cover.(2) 3. Remove the 2 screws from the lamp module.(3) 4.Pull out the lamp module. (4) ...
Question about Sharp Office Equipment & Supplies
...if anybody has any suggestions for me please i want some help Hello, 1.Open the lamp cover and reinstall. 2.open the projector and check the Power Supply 3.check fuse/ thermal cut off switch. ...
3 hours. "Lamp" indicator light is not lit. Could it be the lamp going? Sorry, Sony is having a lot of problems with the light engine ($$$) on these models. Contact Sony as they are covering them even
lamp cover with a Phillips head screw driver and remove the lamp cover. 4. Remove the two screws that hold the lamp in place. Remove the lamp unit by holding the lamp handle, then pulling outwards. 5.
...lamp cover with a Phillips head screw driver. Remove the lamp cover.4. Remove the two screws that hold the lamp in place. Remove the lamp unit by holding the lamp handle, then pulling ...
Question about Promethean Board Office Equipment & Supplies
...cover over lamp area There are 3 screws in lamp unit (they have little arrows that point to them even) or check against new lamp to make sure you take out the correct ones Pull straight up, place new ...
7 questions posted
Usually answered in minutes!
94 Questions
59 Questions
55 Questions
35 Questions
28 Questions