Sharp Aquos LC-37G4U 37 in. HD-Ready LCD Television "reset error" Questions

...you can make it go into a coma and not turn back on again. It may not work to perform a factory reset INIT (industry initialization) but call sharp aquos 877-322-7867 (87seeaquos) to get a case ...

...error counter wich must be reset to 0. Max is 5 faults,if a sixth error is measured the set stops. i followed tvdokter's advice and got to see green light on both the display and avc system. however, ...

...error and then again to reset them. Once the lamp errors have been reset to 0, unplug the unit and wait at least 25 seconds before plugging in. The unit will now power up normally and this may cure ...

...turn on. help! TV detected lamp error, problem could be either INVERTER UNIT or one of the lamps. Defective part has to be replaced, lamp error counter reset. light power blinks can turn tv on or ...

error line. The lamp errors will most likely read 5 and 5 lamp errors in this unit will cause shut down. Use the channel down button on the remote until you highlight that line. Withe the curser right

...reset how would I do that? Not getting any power, only a green blinking light. The power supply board checked out ok. Blinking light is an error code. Count the blinks before they repeat. Check your ...

...reset this. These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will ...

...error data must be reset back to zero. To change data you will need to access the service mode and change the value of lamp error code to zero (0). Entering service mode requires a trained TV ...

...error code, 2 sloww flashes 5 fast. I have done a reset twice These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea ...

error message about every 2-3 weeks. However, the problem could be easily soved by reset TV although I think is not a root solution.Technically speaking, I think this is a Firmware bug, however, it is