Toshiba 50HX81 50" Rear Projection Television "removing hyper board" Questions

...hyper board and remove procedure hyper board removal procedure and location Hyper board is located directly behind the input board, this is where all the tv conections are, then they are two tabs ...

Hyper board location and removal I am also having the same problem with a wavy picture on my 5 year old 50H82. I would like to be able to pull out the hyper board but I do not know where it is located

...Hyper Board on my Toshiba Projection TV-Model #57HX81. Good Luck trying to find one. It's best to repair the original. After you open the back of the tv you'll have to remove some screws holding the ...

removing the hyper board Got everything off but the hyper board itself. I am not sure how to get this part off. Can someone explain this process. I have a Toshiba 57H82. And are the caps inside the ...

...removing hyper module. Got as far as the module but can't figure out how to remove the module itself. Can you explain this process. ...

...Hyper Board location UZ01 stamped MVPU14. You will need to have a technican remove the board and replace all the 10 uF @ 16 Volt SMD caps p/n 24619040N found on that board. The Hyper board is no ...

...hyper board failure My Toshiba is having the problem with the hyper board. I found a place to repair it but I want to see how to remove it. I would like the Toshiba service manual if you have it ...

Hyper" board. It is a circuit in the set that processes all signal from the tuners, and all inputs. Most of the time this problem shows up when the set is first turned on and after several minutes the

Hyper Board. This is how to repair it: MVPU13 Hyper Module Repair (23786198 / 23148017X) Corrective Action: Remove the MVUP13 Hyper Module from the TV chassis, remove the top shield and replace all of

...much in the hyper board and that's likely the problem.. Simply remove the hyper board and open the can. Inside you'll see a number of smd caps. There are 11 10mf/16v that need to be replaced... ...