Kenmore 756A-30BH Mechanical Sewing Machine "6 stitch" Questions

...6-stitch cable with 6 stitches and so on. Most of the time these sets of stitches are divided equally. For the 4-stitch cable the first 2 stitches are slipped purlwise onto a cable needle or double ...

...stitch about every 6-8 stitches Check your stitch pattern because you most likely have machine set to perform a blind stitch. chane your pattern setting to desired stitch and make sure you use ...

...6 stitch indicator it sews a shorter stitches 10 to 12 stitches per inch. I need this longer stitch length to baste. Can you make any suggestions to fix? the stitch length is governed by the cam ...

6 respectively and the stitch width and length knobs to "green", you can vary the length and width to suit what you want. Then for the cams, you need to set everything zero, turn stitch selector to 7,

...6 weeks and now the back stitch is not stitching, thread pulls out from back Do you mean forward direction is ok but reverse is dropping stitches? Try reducing tension and see if that makes a ...

...6) stitches or stitch forward a few stitches. Some people will stitch in place but that frequently causes a knot on the underside of the fabric. You can also tie the thread tails together (especially ...

...# 7 (Z zig-zag) and then press the alternatives button to set the stitch density. Stitches #5 or #6 can also be set to higher density for a satin stitch, if desired. I hope this helps. Cindy ...

...stitch length is not what I have it set for. I set it on 5 I set the length on 5 and stitches as if it were 6 or 8 What can I check to correct this. Consew 226 I assume you mean it stitches 6 or 8 ...

...an attachment? Measure the button, mark the size of hole you want with a pin at each end. sew 6 full width very close zigzag stitches at one end ending on left side , then sew down to the other ...

...6 stitch gauge will yield a project of 8 inches wide (48/6=8). The result would be one project will be 2 inches wider than the other. But that is only half of the problem as you would still need to ...