Peavey PR15 400w PA Speakers "crossover" Questions

...subwoofers. What is the correct pathway? [email protected] The best way is to use a two-way crossover between the mixer and the amplifiers. In your case, the low output from teh crossover ...

Alesis Monitor One crossover assembly removal? What do I have to do to remove and replace the crossover assembly in a Alesis Monitor One? The question is WHY would you replace the crossover network? ...

Hello, What is the proper way to connect an Ashly XR1000 Crossover and a Pyle Pro PTA1400 power amp to my Peavey XR8600 so I can use 2 subs? The subs are not powered, but do have a passive crossover ...

...lost or blown the top end sound in my Alesis Monitor One MKII Speakers, think I need a new PCB crossover board for each... where can I buy them from? Crossovers RARELY blow... most likely the ...

How can I connect my Peavey xr600 mixer amp to my Behringer Super-x Pro cx2310 crossover? That depends on what you want to end up doing. You will end up patching into/out of the jacks on the front. ...

i need replacement crossover because they got burn The crossover in these is very simple and if it is burned, likely your speakers, maybe both, the woofer and tweeter have been damaged and need to be ...

hello i want to know how many speakers can i conecto to my dbx 223xl crossover 3way The speakers don't connect to the crossover at all. The number of speakers is determined by the amplifier and the ...

...mains on same amp and would like to know how This will depend on your Subs. If they have an inbuilt crossover there will be input and outputs on the rear, with the output marked something like 'tops' ...

...an analogue multimeter What you are describing is a total component failure of something in the crossover board. You cannot really check a crossover without an oscilloscope and a frequency ...

...2 subwoofer with amp how can I connect it the best way thank you first, you will need a passive crossover, i do not believe that the mono out of the mixer has a crossover., if the amp does not ...